Author Topic: Z-boards  (Read 2560 times)

Trannyman

  • Guest
Z-boards
« on: April 15, 2010, 04:56:00 pm »
Just picked up a couple new inline Z-boards in Pulaski today,
They look sweeeeeeet.   8-)  8-)

Any body use them yet?

Can't say that I am crazy about the front pin release.  May try a different set up next week in Dalhousie.    ;D  ;D

Al

SpoonPullers.com

  • Advertisement
  • *****

Strike Zone

  • Guest
Z-boards
« Reply #1 on: April 16, 2010, 08:49:00 am »
I read about them on a different board and the reports looked promising.  Would love to here your first hand report after you have given them a good workout.

rayman96

  • Guest
Z-boards
« Reply #2 on: April 16, 2010, 04:16:00 pm »
Here's their website.

http://www.thezboards.com/

58johnson

  • Guest
Z-boards
« Reply #3 on: May 20, 2010, 11:15:00 pm »
I have used the Little Sisters version. Overall excellent. I can come to a complete stop without them tipping over. They run well out to the sides of the boat. There are bigger versions for heavier  lines. I use braid and stickbaits. Can't say enough good about them. They work pretty well in waves for their size. I busted one up by adjusting it too strongly. They got me a new one immediately.

r5dogs

  • Guest
Z-boards
« Reply #4 on: June 07, 2010, 05:53:00 pm »
So Far I like them! Been useng since 1st scotty

rockandtroll

  • Guest
Z-boards
« Reply #5 on: July 11, 2010, 09:06:00 pm »
Tried my new Z board tonight pulling a 450 copper. Didn't like the pin, tried using 2 of the red releases that come with them instead and that worked better. Still need some fine tuning.
Mike

patkirby

  • Guest
Z-boards
« Reply #6 on: July 12, 2010, 04:24:00 pm »
Looks just like the Big Jon Otter boards,,, same clip

ChasinTail

  • Guest
Z-boards
« Reply #7 on: July 29, 2010, 01:06:00 pm »
I love mine! I too changed around the front release to an OR-16

rwsfishing

  • Guest
Z-boards
« Reply #8 on: August 03, 2010, 10:17:00 am »
I tried them last weekend and could not keep the front push pin release from releasing. within 5 minutes it would release. Sent them an email two days ago -- no reply yet.